This DTC is stored when the windshield wiper motor assembly detects an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | DTC Output from |
|---|---|---|---|---|---|
| B1370 | ECU Malfunction | Detection condition:
Battery voltage is 9.5 V or more Malfunction Status:
A malfunction is detected for during the windshield wiper motor assembly self-check. Malfunction Time:
10 seconds or more |
Windshield wiper motor assembly | ○ | Wiper |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Wiper / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Wait 10 seconds or more.
Turn the GTS on.
Enter the following menus: Body Electrical / Wiper / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC B1370 is not output | A |
| DTC B1370 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B