Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320460 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


PROCEDURE

Hide 1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)

Hide 45024 2.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY

NOTICE:

Removing the lower steering column cover sub-assembly in the incorrect order will cause the parts to break.


a.

for Manual Tilt and Manual Telescopic Steering Column:

i.

Release the tilt and telescopic lever and fully extend and lower the steering column assembly.


ii.

Lock the tilt and telescopic lever.



b.
E364804

Turn the steering wheel assembly to the left and remove the screw.


c.
E364805

Turn the steering wheel assembly to the right and remove the screw.


d.
E364806

Remove the screw.


e.
E364807C01
0,0 0,0 false
V100135

Push


Push the lower steering column cover sub-assembly and disengage the 2 claws as shown in the illustration.


f.
E364809

Disengage the 2 claws to remove the lower steering column cover sub-assembly.


Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

a.
E364810C01
0,0 0,0 false
V113147

Separate in this Direction


Disengage the claw to separate the upper steering column cover as shown in the illustration.


b.
E364812

Disengage the 2 claws and 4 clips to remove the upper steering column cover from the instrument cluster finish panel assembly.


Hide 84650 4.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E364813C01
0.927,1.51 1.354,1.427 true 0.74,1.448 0.927,1.625 0.188,0.177 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

NOTICE:

If the claw is pulled with excessive force, it may break.


HINT:

Tape the screwdriver tip before use.