Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2017.09–2017.12
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320460 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for LHD)

a.
E378157C01
1.781,0.948 1.781,0.479 1.781,0.479 1.979,0.479 false 1.635,0.948 1.635,0.479 1.635,0.479 1.438,0.479 false 1.469,1.906 1.646,1.906 1.646,1.906 1.646,1.281 false 1.969,1.906 1.781,1.906 1.781,1.906 1.781,1.281 false 2.104,1.781 1.917,1.781 1.917,1.781 1.917,1.271 false 1.344,1.781 1.51,1.781 1.51,1.781 1.51,1.271 false 2.25,1.656 2.063,1.656 2.063,1.656 2.063,1.271 false 1.208,1.656 1.375,1.656 1.375,1.656 1.375,1.271 false 0.563,2.031 1.427,2.302 false 0.5,2.323 1.417,2.417 false 0.531,2.604 1.448,2.521 false 0.594,2.885 1.49,2.625 false 0.115,0.094 0.427,0.292 0.313,0.198 10 false *a 0.323,1.927 0.635,2.125 0.313,0.198 10 false P4 0.281,2.25 0.594,2.448 0.313,0.198 10 false P3 0.281,2.521 0.594,2.719 0.313,0.198 10 false P2 0.354,2.844 0.667,3.042 0.313,0.198 10 false P1 0.958,1.542 1.271,1.74 0.313,0.198 10 false WF 1,1.708 1.479,1.927 0.479,0.219 10 false MIST 1.271,1.844 1.583,2.042 0.313,0.198 10 false +S 2.01,1.813 2.323,2.01 0.313,0.198 10 false +2 2.156,1.688 2.469,1.885 0.313,0.198 10 false +1 2.292,1.542 2.917,1.865 0.625,0.323 10 false W-OFF 2.031,0.385 2.344,0.583 0.313,0.198 10 false VR 1.302,0.406 1.615,0.604 0.313,0.198 10 false E
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Condition Specified Condition
14 (MIST) - 5 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
10 (W-OFF) - 5 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
13 (+S) - 5 (E) AUTO position Below 1 Ω
Except AUTO position 10 kΩ or higher
11 (+1) - 5 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
12 (+2) - 5 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Washer Switch
Tester Connection Condition Specified Condition
15 (WF) - 5 (E) ON position Below 1 Ω
OFF position 10 kΩ or higher

Auto Sensitivity Adjustment Switch
Tester Connection Condition Specified Condition
4 (VR) - 5 (E) P1 position 1102 Ω to 1218 Ω
P2 position 570 Ω to 630 Ω
P3 position 256.5 Ω to 283.5 Ω
P4 position Below 1 Ω


If the result is not as specified, replace the windshield wiper switch assembly.


Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for RHD)

a.
E378158C01
1.781,0.948 1.781,0.531 1.781,0.531 1.99,0.531 false 1.635,0.948 1.635,0.531 1.635,0.531 1.458,0.531 false 1.438,1.875 1.635,1.875 1.635,1.875 1.635,1.271 false 1.979,1.875 1.781,1.875 1.781,1.875 1.781,1.271 false 2.125,1.729 1.927,1.729 1.927,1.729 1.927,1.271 false 1.333,1.729 1.51,1.729 1.51,1.729 1.51,1.271 false 2.25,1.594 2.052,1.594 2.052,1.594 2.052,1.271 false 1.188,1.594 1.375,1.594 1.375,1.594 1.375,1.271 false 0.5,1.906 2.052,2.281 false 0.458,2.188 2.063,2.417 false 0.469,2.479 2.042,2.531 false 0.479,2.781 2.01,2.635 false 0.156,0.104 0.469,0.302 0.313,0.198 10 false *a 0.271,1.802 0.583,2 0.313,0.198 10 false P4 0.25,2.104 0.563,2.302 0.313,0.198 10 false P3 0.26,2.396 0.573,2.594 0.313,0.198 10 false P2 0.271,2.719 0.583,2.917 0.313,0.198 10 false P1 1.219,0.438 1.531,0.635 0.313,0.198 10 false VR 2.052,0.438 2.365,0.635 0.313,0.198 10 false E 0.708,1.49 1.365,1.75 0.656,0.26 10 false W-OFF 1.125,1.646 1.438,1.844 0.313,0.198 10 false +1 1.24,1.792 1.552,1.99 0.313,0.198 10 false +2 2.042,1.792 2.354,1.99 0.313,0.198 10 false +S 2.167,1.635 2.698,1.885 0.531,0.25 10 false MIST 2.302,1.479 2.615,1.677 0.313,0.198 10 false WF
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Condition Specified Condition
11 (MIST) - 4 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
15 (W-OFF) - 4 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
12 (+S) - 4 (E) AUTO position Below 1 Ω
Except AUTO position 10 kΩ or higher
14 (+1) - 4 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
13 (+2) - 4 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Washer Switch
Tester Connection Condition Specified Condition
10 (WF) - 4 (E) ON position Below 1 Ω
OFF position 10 kΩ or higher

Auto Sensitivity Adjustment Switch
Tester Connection Condition Specified Condition
5 (VR) - 4 (E) P1 position 1102 Ω to 1218 Ω
P2 position 570 Ω to 630 Ω
P3 position 256.5 Ω to 283.5 Ω
P4 position Below 1 Ω


If the result is not as specified, replace the windshield wiper switch assembly.