Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320461 WASHER MOTOR G

WIPER / WASHER  WASHER MOTOR  INSPECTION  


PROCEDURE

Hide 85310 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

E287656C05
0.188,0.156 0.5,0.313 0.313,0.156 10 false *a
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


a.

Remove the washer jar.


b.

Disconnect the windshield washer motor and pump assembly connector.

HINT:

This check should be performed with the windshield washer motor and pump assembly installed on the washer jar.



c.

Fill the washer jar with washer fluid.


d.

Connect a battery positive (+) lead to terminal 1 of the windshield washer motor and pump assembly, and a negative (-) lead to terminal 2.


e.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the windshield washer motor and pump assembly.