Home › Vehicle Exterior › WIPER / WASHER › RELAY › 2017.09–2018.04
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320464 RELAY G

WIPER / WASHER  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85940 1.INSPECT WIPER RELAY

a.
E367719N02
1.146,0.948 1.313,0.49 false 1.281,1.771 1.125,1.333 false 0.802,0.99 0.969,0.531 false 0.719,1.719 0.563,1.281 false 1.323,0.302 1.635,0.5 0.313,0.198 10 false 1 1.292,1.771 1.604,1.969 0.313,0.198 10 false 2 0.969,0.344 1.281,0.542 0.313,0.198 10 false 5 0.719,1.74 1.031,1.938 0.313,0.198 10 false 3

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the WIPER relay.


Hide 85942 2.INSPECT WASHER RELAY

a.
E366995N01
1.417,0.313 1.333,0.313 1.333,0.313 1.333,0.979 false 0.635,0.302 0.552,0.302 0.552,0.302 0.552,0.969 false 1.052,0.313 0.948,0.313 0.948,0.313 0.948,0.719 false 0.375,1.917 0.958,1.917 0.958,1.917 0.958,1.5 false 0.677,0.219 0.833,0.417 0.156,0.198 10 false 2 0.281,1.833 0.438,2.031 0.156,0.198 10 false 5 1.458,0.219 1.615,0.417 0.156,0.198 10 false 1 1.083,0.219 1.24,0.417 0.156,0.198 10 false 3

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the WASHER relay.