Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0321233 HEADLIGHT CLEANER MOTOR G

WIPER / WASHER  HEADLIGHT CLEANER MOTOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

HINT:

This check should be performed with the headlight cleaner motor and pump assembly installed to the washer jar.


a.

Remove the washer jar.


b.

Disconnect the headlight cleaner motor and pump assembly connector.


c.

Fill the washer jar with washer fluid.


d.
E190232C17
0.167,0.115 0.521,0.385 0.354,0.271 10 false *a
*a Component without harness connected
(Headlight Cleaner Motor and Pump Assembly)


Connect a positive (+) lead from the battery to terminal 2 and a negative (-) lead to terminal 1 of the headlight cleaner motor and pump assembly connector.


e.

Check that washer fluid flows from the washer jar.

OK:

The headlight cleaner motor and pump assembly operates and washer fluid flows from the headlight cleaner motor and pump assembly.


If the result is not as specified, replace the headlight cleaner motor and pump assembly.