Home › Drivetrain › UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › VALVE BODY ASSEMBLY
RM33A0E _52 Drivetrain _065352 UB80E AUTOMATIC TRANSMISSION / TRANSAXLE _0321821 VALVE BODY ASSEMBLY A

UB80E AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Transmission valve body assembly

·

Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve


1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)for UB80E Initialization
(Click here)for UB80E Registration

PROCEDURE

Hide 35410 2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C361011

Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.


b.
C369211

Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.


c.
C369212C01
2.708,1.688 2.948,1.885 0.24,0.198 10 true *1 2.635,1.99 2.854,2.167 0.219,0.177 10 true *1 2.031,0.302 2.24,0.49 0.208,0.188 10 true *1 1.198,1.938 1.406,2.135 0.208,0.198 10 true *2 1.135,1.615 1.344,1.813 0.208,0.198 10 true *3
*1 Transaxle Case Gasket
*2 No. 1 Front Oil Pump Cover Gasket
*3 No. 2 Front Oil Pump Cover Gasket


Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.


d.

Remove the transaxle case gasket from the counter drive gear sub-assembly.


e.

Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.


f.

Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.