Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065373 AUDIO / VIDEO _0323011 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the skid control ECU (Brake Actuator Assembly) to the radio and display receiver assembly.

WIRING DIAGRAM

E372242E15
2.5,1.479 3.104,1.719 0.604,0.24 10 false A34 2.5,1.646 4.021,2.094 1.521,0.448 10 false Skid Control ECU (Brake Actuator Assembly) 3.719,0.969 4.323,1.208 0.604,0.24 10 false 33 5.219,1.99 5.823,2.229 0.604,0.24 10 false K2 5.219,2.146 6.406,2.594 1.188,0.448 10 false Radio and Display Receiver Assembly 5.417,1.083 6.021,1.323 0.604,0.24 10 false PKB 5.146,0.99 5.75,1.229 0.604,0.24 10 false 20 3.323,1.115 3.927,1.354 0.604,0.24 10 false PKB

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the K2 radio and display receiver assembly connector.


b.

Disconnect the A34 skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K2-20 (PKB) - A34-33 (PKB) Always Below 1 Ω
K2-20 (PKB) or A34-33 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR