Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH
RM33A0E _58 Vehicle Interior _065381 METER / GAUGE / DISPLAY _0323399 TRIP SWITCH G

METER / GAUGE / DISPLAY  TRIP SWITCH  INSPECTION  


PROCEDURE

Hide 84975 1.INSPECT TRIP SWITCH

a.
E366900C05
2.135,3.958 2.531,3.219 false 1.729,3.958 1.865,3.188 false 1.542,3.958 1.292,3.219 false 1.927,3.948 2.229,3.208 false 1.323,3.958 0.906,3.198 false 1.198,3.01 1.427,3.219 0.229,0.208 10 false RV 2.521,3.021 2.656,3.219 0.135,0.198 10 false E 1.75,3.01 2.021,3.198 0.271,0.188 10 false A/B 0.396,3.229 0.625,3.438 0.229,0.208 10 false *a 2.156,3.01 2.427,3.198 0.271,0.188 10 false ILL- 0.781,3 1.083,3.198 0.302,0.198 10 false ILL+
*a Component without harness connected
(Trip Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (RV) - 1 (E) Light control rheostat up switch pressed Below 50 Ω
Light control rheostat up switch not pressed 10 kΩ or higher
4 (RV) - 1 (E) Light control rheostat down switch pressed 1.71 to 1.94 kΩ
Light control rheostat down switch not pressed 10 kΩ or higher
3 (A/B) - 1 (E) ODO/TRIP switch pressed Below 50 Ω
ODO/TRIP switch not pressed 10 kΩ or higher


If the result is not as specified, replace the trip switch.


b.

Apply battery voltage to the trip switch and check that it illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the trip switch.