Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side of Bank 1)
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326372 CAMSHAFT OIL CONTROL VALVE(for Intake Side of Bank 1) A

2GR-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side of Bank 1)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53736 2.REMOVE FRONT FENDER APRON SEAL RH

Hide 11209 3.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 15370 4.REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1)

Hide 5.SET NO. 1 CYLINDER TO TDC/COMPRESSION

a.
A368570C01
1.698,1.292 2.188,1.292 true 1.469,1.313 1.198,1.719 1.198,1.719 0.958,1.719 true 2.198,1.198 2.375,1.396 0.177,0.198 10 true *a 0.781,1.646 0.958,1.844 0.177,0.198 10 true *b
*a Timing Mark
*b Timing Mark (Cutout)


Turn the crankshaft pulley clockwise until its timing mark (cutout) is aligned with the timing mark on the timing chain cover assembly as shown in the illustration.


b.

Check that the cutout of the camshaft timing gear assembly is at the top.

A396005C01
2.198,0.854 1.521,0.531 1.521,0.531 1.302,0.531 true 5.188,1.177 5.615,1.177 true 5.385,2.781 5.688,2.781 true 3.24,3.49 2.979,3.49 2.979,3.49 2.896,3.208 true 0.906,1.115 1.219,1.271 0.313,0.156 10 false *a 0.979,2.885 1.292,3.042 0.313,0.156 10 false *b 1.146,0.438 1.458,0.594 0.313,0.156 10 false *c 1.531,0.885 1.844,1.042 0.313,0.156 10 false *d 5.656,1.083 5.958,1.302 0.302,0.219 10 true *c 5.74,2.688 6.042,2.906 0.302,0.219 10 true *c 3.271,3.406 3.573,3.625 0.302,0.219 10 true *c 1.542,2.719 1.854,2.875 0.313,0.156 10 false *d
*a Correct *b Incorrect
*c Cutout *d Up


HINT:

If the cutout of the camshaft timing gear assembly is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing chain cover assembly again.



Hide 6.REMOVE CAMSHAFT TIMING GEAR BOLT

a.
A408183

While holding the crankshaft pulley, remove the camshaft timing gear bolt.

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.