Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>PROBLEM SYMPTOMS TABLE
12361A
1.INSPECT FRONT ENGINE MOUNTING INSULATOR
Disconnect the vacuum hose from the front engine mounting insulator.
Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.
Check that there is no change in the needle movement of the vacuum pump gauge.
Vacuum pressure holds.
Check that there is no fluid leakage caused by a break in the diaphragm.
Connect the vacuum hose to the front engine mounting insulator.