Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>PROBLEM SYMPTOMS TABLE
12371A
1.INSPECT REAR ENGINE MOUNTING INSULATOR
Disengage the clamp to separate the vacuum hose.
Disconnect the vacuum hose.
Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.
Check that there is no change in the needle movement of the vacuum pump gauge.
Vacuum pressure holds.
Check that there is no fluid leakage caused by a break in the diaphragm.
Connect the vacuum hose.
Engage the clamp to install the vacuum hose.