Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326389 AIR FUEL RATIO SENSOR A

2GR-FKS ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 11209 1.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 89467B 2.REMOVE AIR FUEL RATIO SENSOR (for Bank 2)

a.
A408208

Disengage the wire harness clamp.


b.

Disconnect the air fuel ratio sensor connector.


c.
A408209N01
1.688,1.906 1.688,1.635 true 1.583,1.917 2.042,2.115 0.458,0.198 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold assembly LH (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.



Hide 89467C 3.REMOVE AIR FUEL RATIO SENSOR (for Bank 1)

a.
A408211

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 wire harness clamps.


c.
A408212N01
1.24,1.292 1.885,1.292 true 1.906,1.208 2.365,1.406 0.458,0.198 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold assembly RH (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.