When removing and installing the combination meter glass, make sure not to touch the display panel.
Do not allow any dirt, fingerprints, grease, etc., to adhere to the combination meter glass. If the glass is dirty, wipe it clean with a soft cloth.
83138G
1.INSTALL COMBINATION METER GLASS (for Type A)
|
Install in this Direction |
Engage the 8 claws to install the combination meter glass.
83138G
2.INSTALL COMBINATION METER GLASS (for Type B)
|
Install in this Direction |
Install the combination meter glass as shown in the illustration.
| *1 | Rear Cover |
Do not remove the rear cover from the combination meter assembly as foreign matter may enter the combination meter assembly and cause a malfunction.
Using a "TORX" driver T10, install the combination meter glass with the 8 screws.