Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY › 2017.09–2018.04
RM33A0E _58 Vehicle Interior _065381 METER / GAUGE / DISPLAY _0326543 HEADUP DISPLAY A

METER / GAUGE / DISPLAY  HEADUP DISPLAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headup display (meter mirror sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

HINT:

Use the same procedure as for the LHD.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL


Hide 55971C 2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

HINT:

Use the same procedure as for LHD.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>DISASSEMBLY


Hide 55972C 3.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

HINT:

Use the same procedure as for LHD.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>DISASSEMBLY


Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

HINT:

Use the same procedure as for LHD.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>DISASSEMBLY


Hide 83108 5.REMOVE METER MIRROR SUB-ASSEMBLY

a.
E371505

Remove the 3 screws and meter mirror sub-assembly.