Home › Drivetrain › U760E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM › 2017.09–2021.02
RM33A0E _52 Drivetrain _065350 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0322783 AUTOMATIC TRANSAXLE SYSTEM D

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C370671

Disconnect the wiring harness connector connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the wiring harness connector connector. The gears can then be changed mechanically with the shift lever.



b.

Drive the vehicle with the wiring harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

Shift Lever Position Gear
P P
R R
D 3rd
No Shift (Gear will not change)


c.

Connect the wiring harness connector connector.


d.

Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
50002 234