Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0322781 AUTOMATIC TRANSAXLE SYSTEM D

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


MANUAL SHIFTING TEST


HINT:
·

Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C379043

Disconnect the transmission wire connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the transmission wire. The gears can then be changed mechanically with the shift lever.



b.

Drive the vehicle with the transmission wire connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

Shift Lever Position Gear
P P
R R
D 5th
No Shift (Gears will not change)


c.

Connect the transmission wire connector.