Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (except 2AR-FE) › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0326622 CRUISE CONTROL SYSTEM(except 2AR-FE) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(except 2AR-FE)  P057504  Cruise Control System Internal Failure  P057549  Cruise Control Internal Electronic Failure  


DESCRIPTION

This DTC is stored when there is a malfunction in the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P057504 Cruise Control System Internal Failure While the cruise control system is operating, the cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed since cruise cancel signal (STP signal) is input to the ECM. ECM
P057549 Cruise Control Internal Electronic Failure When the engine switch is on (IG), STP signals input to the ECM supervisory CPU and that input to the control ECU do not match for approximately 0.2 seconds or more. ECM

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the engine switch is turned off.


PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed for which cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch.

3.

Depress the brake pedal for 1 second or more.




c.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 374
OK:

DTC P057504 and P057549 are not output.



Result:
Proceed to
OK
NG



OK

NG