DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A52 | Radar Cruise Control Presence Determination Malfunction (Engine / HV) | Approximately 17 seconds after the engine switch is on (IG), the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 1.3 seconds or more. | ·
ECM ·
Millimeter wave radar sensor assembly |
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
Before replacing the ECM, refer to Service Bulletin.
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the engine switch on (IG).
Wait for 20 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A52 is not output | A |
| DTC C1A52 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Replace the ECM.
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the engine switch on (IG).
Wait for 20 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A52 is not output | A |
| DTC C1A52 is output | B |
A
B