Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (except 2AR-FE) › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0326623 DYNAMIC RADAR CRUISE CONTROL SYSTEM(except 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(except 2AR-FE)  P057113  Brake Switch "A" Circuit Open  


DESCRIPTION

When the brakes are applied by the dynamic radar cruise control system, the skid control ECU (brake actuator assembly) operates the stop light switch assembly (stop light control relay) to illuminate the stop lights.

If the ECM receives a stop light control relay malfunction signal from the skid control ECU (brake actuator assembly), DTC P057113 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
P057113 Brake Switch "A" Circuit Open While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the ECM detects the stop light control relay malfunction signal from the skid control ECU (brake actuator assembly) for approximately 0.5 seconds or more. Pre-collision system

CAUTION / NOTICE / HINT

HINT:

When DTC P057113 is stored by the dynamic radar cruise control system, DTC C1A4B is stored by the pre-collision system. Therefore, if DTC P057113 is stored, inspect the pre-collision system first.


PROCEDURE

1.GO TO PRE-COLLISION SYSTEM

NEXT

END