Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT SWITCH
RM33A0E _58 Vehicle Interior _065380 LIGHTING (INT) _0327000 VANITY LIGHT SWITCH G

LIGHTING (INT)  VANITY LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 74320 1.INSPECT VISOR ASSEMBLY LH

E224621C07
1.302,2.25 1.135,2.25 1.135,2.25 1.042,3.083 false 1.677,2.708 1.802,2.135 1.802,2.135 1.906,2.135 false 1.813,3.771 1.885,4.104 1.885,4.104 1.99,4.104 false 0.292,0.25 0.563,0.458 0.271,0.208 10 false *a 1.969,2.073 2.24,2.281 0.271,0.208 10 false *b 2.021,4.031 2.292,4.24 0.271,0.208 10 false *c 1.365,2.198 1.635,2.406 0.271,0.208 10 false *d
*a Component without harness connected
(Visor Assembly LH)
*b Visor up
*c Visor down
*d Mirror Cover


a.

Inspect the vanity light switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly LH.



Hide 74310 2.INSPECT VISOR ASSEMBLY RH

E224622C07
1.333,1.781 1.5,1.781 1.5,1.781 1.625,2.625 false 2.375,3.052 2.26,2.333 2.26,2.333 2.156,2.333 false 1.698,3.781 1.552,4.083 1.552,4.083 1.448,4.083 false 0.24,0.25 0.51,0.458 0.271,0.208 10 false *a 1.156,1.719 1.427,1.927 0.271,0.208 10 false *b 1.26,4.01 1.531,4.219 0.271,0.208 10 false *c 2,2.271 2.271,2.479 0.271,0.208 10 false *d
*a Component without harness connected
(Visor Assembly RH)
*b Visor up
*c Visor down
*d Mirror Cover


a.

Inspect the vanity light switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly RH.