Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
81536A
1.REMOVE REAR COMBINATION LIGHT LED (for Bulb Type Back-up Light)
Disconnect the connector.
Remove the screw.
|
Remove in this Direction |
Turn the rear combination light LED as shown in the illustration to remove it.
81552C
2.REMOVE REAR COMBINATION LIGHT GASKET (for Bulb Type Back-up Light)
Remove the rear combination light gasket.
After the rear combination light gasket is removed, be sure to replace it with a new one. Failure to do so may cause water ingress.
81550L
3.REMOVE REAR TURN SIGNAL LIGHT BULB (for Bulb Type Back-up Light)
|
Disconnect in this Direction |
Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire.
81565E
4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE (for Bulb Type Back-up Light)
Disengage the 2 clamps.
Disconnect the connector to remove the rear combination light socket and wire.
81565D
5.REMOVE REAR COMBINATION LIGHT CORD (for LED Type Back-up Light)
Disengage the 2 clamps.
Disconnect the connector to remove the rear combination light cord.
81561D
6.REMOVE REAR COMBINATION LIGHT LENS AND BODY (for Bulb Type Back-up Light)