81270
1.INSPECT LICENSE PLATE LIGHT ASSEMBLY
| *a | Component without harness connected
(License Plate Light Assembly) |
Connect 4 dry-cell batteries (1.5 V) in series.
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
Apply 6 V batter voltage to the terminals of the connector and check that the license plate light illuminates.
| Condition | Specified Condition |
|---|---|
| Positive (+) lead from the batteries → Terminal 1 (B)
Negative (-) lead from the batteries → Terminal 2 (E) |
License plate light illuminates |
If the result is not as specified, replace the license plate light assembly.