Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327014 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E379800C01
0,0 0,0 false
V113147

Insert in this Direction


Insert the stop light switch assembly until the threaded sleeve hits the pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E379801C01
1.458,1.792 1.615,1.99 0.156,0.198 10 false a
V113147

Turn in this Direction


Turn the stop light switch assembly 1/4 clockwise to install it.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of the Plunger
Area Measurement
a 0.6 to 2.6 mm (0.0236 to 0.102 in.)


e.

If the protrusion is not as specified, recheck the stop light switch assembly installation and perform brake pedal adjustment if necessary.

for LHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT

for RHD:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT

NOTICE:

Do not depress or support the brake pedal.



Hide 55606 2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)