Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2017.09–2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0327182 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C147D  Air Bag Circuit  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives the secondary collision brake control request signal from the airbag sensor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
C147D Air Bag Circuit An abnormal secondary collision brake control request signal is received 3 times or more when communication with the airbag sensor assembly is possible.
·

Airbag sensor assembly

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK DTC (AIRBAG SYSTEM)
a.

Check if airbag system DTCs are output.

Body Electrical > SRS Airbag > Trouble Codes
50001 188

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B

GO TO DIAGNOSTIC TROUBLE CODE CHART (AIRBAG SYSTEM)