Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2017.09–2021.02
RM33A0E _54 Brake _065365 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0327182 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Brake Hold Operated Indicator Light Circuit  


DESCRIPTION

The brake hold operated indicator light illuminates when the brake hold system is operating (vehicle stopped due to brake fluid pressure hold) and turns off when the brake hold system operation is finished (brake fluid pressure decreases).

The brake hold system may not operate depending on vehicle conditions even when the system is in standby mode and the brake hold standby indicator light is illuminated.

If there is a system malfunction that causes brake hold control to be prohibited, when the vehicle is under the following conditions and the brake hold switch (electric parking brake switch assembly) is pressed, the brake hold operated indicator light blinks.

Vehicle Conditions:

(a)

The driver door is closed.

(b)

The driver seat belt is fastened.



CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.PRE-CHECK
a.

Check that the brake hold standby indicator light operates normally.


b.

If the brake hold operated indicator light does not illuminate even though the brake hold standby indicator light is illuminated, check that the following brake hold operation (brake fluid pressure is being maintained ) conditions are met.

1.

The shift lever is not in P or R.

2.

The vehicle is fully stopped and the driver is depressing the brake pedal.

3.

The driver is not depressing the accelerator pedal.

4.

The vehicle is not on a steep incline.


HINT:

When a malfunction occurs in the brake control system, the brake hold operated indicator light blinks.



Result:
Proceed to
NEXT



NEXT

2.INSPECT COMBINATION METER ASSEMBLY
2.INSPECT COMBINATION METER ASSEMBLY
a.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


b.

Perform the Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display
Hold Indicator
50004 409 118

c.

Check the combination meter assembly.

OK:

The brake hold operated indicator light turns on or off in accordance with the GTS operation.



Result:
Proceed to
OK
NG



OK

3.PERFORM ACTIVE TEST USING GTS (BRAKE HOLD OPERATED INDICATOR LIGHT)

NG

3.PERFORM ACTIVE TEST USING GTS (BRAKE HOLD OPERATED INDICATOR LIGHT)
a.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
BH Operated Light Brake hold operated indicator light Indicator light OFF/ON
·

Observe combination meter assembly

·

Perform the Active Test with the vehicle stopped


Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
BH Operated Light Brake hold operated indicator light ON or OFF ON: Indicator light on
OFF: Indicator light off
-
Chassis > ABS/VSC/TRC > Active Test
Active Test Display
BH Operated Light
Data List Display
BH Operated Light
50004 105 74 281

b.

Check the operating condition of the brake hold operated indicator light when operating it using the GTS.


Result:
Result Proceed to
Brake hold operated indicator light in the Data List does not change using the Active Test. A
Brake hold operated indicator light in the Data List turns ON/OFF using the Active Test. B



A

B