The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat cushion heater assembly RH removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY RH
71073S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
72494
3.REMOVE VERTICAL ADJUSTING HANDLE RH
72551B
4.REMOVE RECLINING HINGE COVER RH
72525A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71848A
6.REMOVE SEAT ADJUSTER COVER CAP RH
71811D
7.REMOVE FRONT SEAT CUSHION SHIELD RH
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD RH
9.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
10.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71071S
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510K
12.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY RH
Remove the 35 tag pins and front seat cushion heater assembly RH from the separate type front seat cushion cover.