Home › Vehicle Interior › SEAT › POWER SEAT CONTROL ECU › 2017.09–2018.04
RM33A0E _58 Vehicle Interior _065385 SEAT _0327235 POWER SEAT CONTROL ECU A

SEAT  POWER SEAT CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly RH removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Position control ECU assembly (driver seat)

·

Front seatback frame sub-assembly (driver seat)

·

Front seat adjuster assembly (driver seat)


Initialize position control ECU Front power seat control system (Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY RH

Hide 89710C 2.REMOVE POSITION CONTROL ECU ASSEMBLY RH

a.
B490199C01
0,0 0,0 false
V100135

Screw
V100136

Connector


Disconnect the 3 connectors.


b.

Remove the 3 screws and position control ECU assembly RH.