Home › Vehicle Interior › SEAT › SEAT HEATER CONTROL › 2017.09–2021.02
RM33A0E _58 Vehicle Interior _065385 SEAT _0327236 SEAT HEATER CONTROL A

SEAT  SEAT HEATER CONTROL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat heater control sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Occupant detection ECU

·

Front passenger seat


Zero point calibration (Occupant classification system)
·

Occupant classification system

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)

CAUTION:
·

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 87501B 2.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY

a.
B475585C02
0.719,2.167 1.135,2.167 1.135,2.167 1.615,1.531 true 0.51,2.063 0.719,2.292 0.208,0.229 10 true *a
*a Protective Tape
V113147

Remove in this Direction


Disconnect the connector.


b.

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the seat heater control sub-assembly as shown in the illustration.