Home › General › MAINTENANCE › FRONT BRAKE FLEXIBLE HOSE
RM33A0E _V1 General _065356 MAINTENANCE _0327197 FRONT BRAKE FLEXIBLE HOSE A

MAINTENANCE  FRONT BRAKE FLEXIBLE HOSE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47313J 3.REMOVE FRONT FLEXIBLE HOSE

a.
C369829

Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.


b.
C369722

Remove the bolt and separate the front flexible hose from the front shock absorber assembly.


c.
C369858

Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




d.

Remove the clip and front flexible hose from the vehicle body.