Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327280 CRUISE CONTROL SYSTEM(for 2AR-FE) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for 2AR-FE)  U0122  Lost Communication With Vehicle Dynamics Control Module  


DESCRIPTION

The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0122 Lost Communication with Vehicle Dynamics Control Module While the ignition switch is ON and the cruise control system is operating, signals cannot be received from the skid control ECU (brake actuator assembly) for 2.65 seconds or more.
·

CAN communication system

·

ECM

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

HINT:

Refer to troubleshooting in CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 237

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the ignition switch to ON.

2.

Turn the cruise control system on using the cruise control main switch.

3.

Wait for 3 seconds or more.




c.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 237

Result:
Result Proceed to
DTC U0122 is not output A
DTC U0122 is output B



A

B