DTC B1787 is stored when the occupant detection ECU receives a collision detection signal sent by the rear occupant classification sensor LH in the case of an accident.
DTC B1787 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident did not occur.
If the vehicle was not in a collision, but the occupant detection ECU receives a collision detection signal and stores DTC B1787, the DTC can be cleared by performing zero point calibration. Therefore, if DTC B1787 is output, first perform zero point calibration.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1787 | Rear Occupant Classification Sensor LH Collision Detection | ·
Rear occupant classification sensor LH sensed large load. ·
Front seat adjuster assembly RH malfunction |
Rear occupant classification sensor LH (Front seat adjuster assembly RH)* |
*: The rear occupant classification sensor LH is built into the front seat adjuster assembly RH.
When this DTC is stored, repair of the malfunction indicated can only be performed by initializing the occupant detection ECU or replacing the front seat adjuster assembly RH. Do not replace the occupant detection ECU to repair the malfunction indicated by this DTC.
If the occupant detection ECU is replaced, this DTC will not be output but the occupant detection system may not function properly.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When DTC B165A is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1787 is output, perform troubleshooting for this DTC first.
Using the GTS, perform Zero Point Calibration.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>INITIALIZATION
"Zero Point Calibration is complete." is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch to ON, and wait for at least 60 seconds.
Clear the DTCs stored in the occupant detection ECU.
Clear the DTCs stored in the airbag sensor assembly.
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 10 seconds.
Check for DTCs.
DTC B1787 is not output.
Codes other than DTC B1787 may be output at this time, but they are not related to this check.
Turn the ignition switch off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Replace the front seat adjuster assembly RH.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
Connect the cable to the negative (-) battery terminal.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, perform Zero Point Calibration.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
Replace the front seat adjuster assembly RH.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
Connect the cable to the negative (-) battery terminal.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, perform Zero Point Calibration.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT