When the engine is running, If refrigerant pressure does not decrease when the A/C switch is turned off, the following factors may be the cause.
| Symptom | Factor |
|---|---|
·
Cooler compressor assembly does not stop operating ·
Refrigerant pressure does not decrease when A/C switch is turned off |
·
Short to +B in air conditioning amplifier assembly circuit malfunction ·
Magnetic clutch relay malfunction ·
Magnet clutch assembly malfunction ·
Harness or connector |
Inspect the fuses for circuits related to this system before performing the following procedure.
Remove the magnetic clutch relay.
Inspect the magnetic clutch relay.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (MG CLT relay) - Body ground | Always | 11 to 14 V |
| 1 (MG CLT relay) - Body ground | Ignition switch off | Below 1 V |
| 1 (MG CLT relay) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K55 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (MG CLT relay) - K55-9 (MGC) | Always | Below 1 Ω |
| 2 (MG CLT relay) or K55-9 (MGC) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C63 magnet clutch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (MG CLT relay) - C63-3 (MG+) | Always | Below 1 Ω |
| 5 (MG CLT relay) or C63-3 (MG+) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Install the magnetic clutch relay.
Connect the C63 magnet clutch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C63-3 (MG+) - Body ground | Engine running
(A/C switch: Off) |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG