Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › 2017.09–2017.12
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0327417 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  A/C Switch Indicator does not Turn On  


DESCRIPTION

If none of the switch indicators on the air conditioning control panel (radio and display receiver assembly)*1 or air conditioning control assembly*2 illuminate, the following factors may be the cause.

Symptom Factor
A/C switch indicator does not illuminate
·

Air conditioning amplifier assembly malfunction

·

Air conditioning control panel (radio and display receiver assembly) malfunction*1

·

Air conditioning control assembly malfunction*2

·

A/C switch malfunction

·

A/C switch indicator malfunction (including when indicator turned off without switch operation)

·

Servo motor initialization (incomplete)

·

Mechanical locking of damper and damper link

·

Refrigerant pressure is extremely low

·

Low detected ambient temperature (including thermistor assembly malfunction)



*1: w/ Radio and Display Receiver

*2: w/o Radio and Display Receiver


PROCEDURE

1.CONFIRM MODEL
Result:
Result Proceed to
w/ Radio and Display Receiver A
w/o Radio and Display Receiver B



A

2.CHECK MALFUNCTION STATUS

B

3.CHECK MALFUNCTION STATUS
2.CHECK MALFUNCTION STATUS
a.

Check the malfunction status of switch indicators on the air conditioning control panel (radio and display receiver assembly).


Result:
Result Proceed to
Indicators are not always illuminated A
Indicators are not illuminated only immediately after starting the engine B



A

4.READ VALUE USING GTS

B

3.CHECK MALFUNCTION STATUS
a.

Check the malfunction status of switch indicators on the air conditioning control assembly.


Result:
Result Proceed to
Indicators are not always illuminated A
Indicators are not illuminated only immediately after starting the engine B



A

4.READ VALUE USING GTS

B

4.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Ambient Temp Sensor Thermistor assembly Min.: -23.30°C (-9.94°F)
Max.: 65.95°C (150.71°F)
Actual ambient temperature displayed Thermistor assembly circuit malfunction
·

When open circuit: -23.30°C (-9.94°F)

·

When short circuit: 65.95°C (150.71°F)


Body Electrical > Air Conditioner > Data List
Tester Display
Ambient Temp Sensor
50003 121 2
OK:

The value displayed is 0°C (32°F) or higher.



Result:
Proceed to
OK
NG



OK

INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET

NG