Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in which direction that motor should operate based on the voltage value.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Read the Data List according to the display on the GTS.
| Tester Display |
|---|
| Tilt Manual Switch Up |
| Tilt Manual Switch Down |
| Telescopic Manual Switch Short |
| Telescopic Manual Switch Long |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Tilt Manual Switch Up | Input state of tilt up switch | OFF or ON | - | - |
| Tilt Manual Switch Down | Input state of tilt down switch | OFF or ON | - | - |
| Telescopic Manual Switch Short | Input state of telescopic contract switch | OFF or ON | - | - |
| Telescopic Manual Switch Long | Input state of telescopic extend switch | OFF or ON | - | - |
The value of each Data List item changes in accordance with the operation of the switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K72 multiplex tilt and telescopic ECU connector.
Disconnect the K44 tilt and telescopic switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K72-5 (VC) - K44-1 (VC) | Always | Below 1 Ω |
| K72-18 (MSW) - K44-3 (MSW) | Always | Below 1 Ω |
| K72-5 (VC) or K44-1 (VC) - Body ground | Always | 10 kΩ or higher |
| K72-18 (MSW) or K44-3 (MSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Multiplex Tilt and Telescopic ECU) |
Reconnect the K72 multiplex tilt and telescopic ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K72-5 (VC) - K72-18 (MSW) | Engine switch on (IG) | 4.9 to 5.1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Tilt and Telescopic Switch) |
Remove the tilt and telescopic switch.
Click hereSteering>STEERING COLUMN>TILT AND TELESCOPIC MANUAL SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K44-1 (VC) - K44-3 (MSW) | Tilt up | 342 to 378 Ω |
| Tilt down | 1890.5 to 2089.5 Ω | |
| Telescopic contract | 750.5 to 829.5 Ω | |
| Telescopic extend | 152 to 168 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG