1. PRECAUTION
When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly or navigation ECU may not operate normally.
After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.
2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
55435B
3.REMOVE NO. 1 METER HOOD CLUSTER
55012A
4.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55480D
5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
55670
6.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
7.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
86453
8.REMOVE MULTI-MEDIA MODULE WIRE
86842
9.REMOVE NO. 1 NAVIGATION WIRE
for LHD:
Disconnect the 3 connectors to remove the No. 1 navigation wire.
for RHD:
Disconnect the 3 connectors to remove the No. 1 navigation wire.
86211J
10.REMOVE NO. 1 RADIO RECEIVER BRACKET
86212C
11.REMOVE NO. 2 RADIO RECEIVER BRACKET
86140A
12.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY
86841
13.REMOVE NAVIGATION ECU