The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation antenna assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55086
2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
3.REMOVE NAVIGATION ANTENNA ASSEMBLY WITH BRACKET
Disconnect the connector.
Disengage the 2 claws.
Remove the 2 screws and navigation antenna assembly with bracket.
86860
4.REMOVE NAVIGATION ANTENNA ASSEMBLY
|
Remove in this Direction |
Disengage the 2 claws and 6 guides to remove the navigation antenna assembly as shown in the illustration.
86862
5.REMOVE NAVIGATION ANTENNA BRACKET