Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › TELEVISION ANTENNA › 2017.09–2018.04
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328086 TELEVISION ANTENNA A

NAVIGATION / MULTI INFO DISPLAY  TELEVISION ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during television antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86050 2.REMOVE TELEVISION ANTENNA ASSEMBLY

NOTICE:

Do not touch the contact points.


a.
E375819

Disconnect the connector.


b.

Remove the nut.


c.

Disengage the guide to remove the television antenna assembly.