The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear television camera assembly removal/installation are shown below.
76801A
1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
2.REMOVE REAR TELEVISION CAMERA ASSEMBLY WITH WIRE
Disconnect the connector.
Disengage the clamp.
|
Remove in this Direction |
Disengage the 2 claws to remove the rear television camera assembly with wire as shown in the illustration.
86799
3.REMOVE TELEVISION CAMERA WIRE
Disconnect the connector to remove the television camera wire.
86790D
4.REMOVE REAR TELEVISION CAMERA ASSEMBLY