Check that the voice guidance settings are not off.
Voice guidance settings are not off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K1 radio and display receiver assembly connector.
Disconnect the K17 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K1-22 (SI+) - K17-6 (VOI+) | Always | Below 1 Ω |
| K1-23 (SI-) - K17-7 (VOI-) | Always | Below 1 Ω |
| K1-22 (SI+) or K17-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| K1-23 (SI-) or K17-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| K17-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG