The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Disconnect the K135 radio and display receiver assembly connector.
Disconnect the K5 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K135-2 (US1-) - K5-9 (UDO-) | Always | Below 1 Ω |
| K135-3 (US1+) - K5-10 (UDO+) | Always | Below 1 Ω |
| K135-5 (USG1) - K5-12 (UJSS) | Always | Below 1 Ω |
| K135-2 (US1-) or K5-9 (UDO-) - Body ground | Always | 10 kΩ or higher |
| K135-3 (US1+) or K5-10 (UDO+) - Body ground | Always | 10 kΩ or higher |
| K135-5 (USG1) or K5-12 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PROBLEM SYMPTOMS TABLE
NG