Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio and display receiver assembly.

WIRING DIAGRAM

E367998E01
2.01,0.792 2.448,1.01 0.438,0.219 10 false 21 1.646,0.906 2.083,1.125 0.438,0.219 10 false SUP 5.073,0.802 5.51,1.021 0.438,0.219 10 false 7 5.104,1.479 5.542,1.698 0.438,0.219 10 false K1 5.104,1.646 6.344,2.063 1.24,0.417 10 false Radio and Display Receiver Assembly 1.021,1.49 1.458,1.708 0.438,0.219 10 false K17 1.01,1.646 2.135,1.938 1.125,0.292 10 false Navigation ECU 5.26,0.927 5.698,1.146 0.438,0.219 10 false SUP

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the K1 radio and display receiver assembly connector.


b.

Disconnect the K17 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K1-7 (SUP) - K17-21 (SUP) Always Below 1 Ω
K1-7 (SUP) or K17-21 (SUP) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR