Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327281 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE)  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The ECM sends signals such as dynamic radar cruise control operation signals, brake operation demand signals and buzzer operation demand signals to the skid control ECU (brake actuator assembly) when the dynamic radar cruise control is operating. Therefore, if the skid control ECU (brake actuator assembly) detects a communication error with the ECM, it sends a malfunction signal back to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1631 Communication Error from ECM to VSC While the engine switch is on (IG) and the dynamic radar cruise control system is operating, the ECM continuously receives a logic error signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

Vehicle stability control system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)

B

2.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Powertrain > Radar Cruise1 > Clear DTCs
50002 239

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the engine switch on (IG).

2.

Turn the dynamic radar cruise control system on using the cruise control main switch.

3.

Wait for 1 second or more.




c.

Check for DTCs.

Powertrain > Radar Cruise1 > Trouble Codes
50001 239

Result:
Result Proceed to
DTC P1631 is not output A
DTC P1631 is output B



A

B