Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327281 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE)  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC is stored when there is a malfunction in the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P0575 Cruise Control Input Circuit
·

While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed since cruise cancel signal (STP signal) is received by the ECM.

·

While the dynamic radar cruise control system is operating, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more.


ECM

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the engine switch is turned off.


PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Powertrain > Radar Cruise1 > Clear DTCs
50002 239

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.

2.

Turn the dynamic radar cruise control system on using the cruise control main switch.

3.

Depress the brake pedal for 1 second or more.




c.

Check for DTCs.

Powertrain > Radar Cruise1 > Trouble Codes
50001 239

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B