Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Disc cannot be Ejected  


CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.




PROCEDURE

1.CHECK OPERATION
a.

Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the disc is ejected.

OK:

Disc is ejected.



Result:
Proceed to
OK
NG



OK

2.REPLACE DISC AND RECHECK

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.REPLACE DISC AND RECHECK
a.

Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Disc is ejected.



Result:
Proceed to
OK
NG



OK

END (DISC WAS FAULTY)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY