Home › Power Source / Network › 2GR-FKS (BATTERY / CHARGING) › CHARGING SYSTEM
RM33A0E _57 Power Source / Network _065340 2GR-FKS BATTERY / CHARGING _0328307 CHARGING SYSTEM C

2GR-FKS BATTERY / CHARGING  CHARGING SYSTEM  P161A87  Lost Communication with Alternator Missing Message  


DESCRIPTION

The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P161A87 Lost Communication with Alternator Missing Message Generator assembly or ECM communication stops for approximately 17 minutes or more with the engine switch on (IG).
(1 trip detection logic)
·

Wire harness and connector

·

Generator assembly

·

ECM


Charge warning is not displayed DTC stored SAE Code: P161A

WIRING DIAGRAM

A340530E59
1.51,3.167 5.177,3.365 3.667,0.198 10 false : LIN Communication Line 5.125,2.521 6.354,2.719 1.229,0.198 10 false C96 1.677,2.208 2.135,2.406 0.458,0.198 10 false C60 1.677,2.375 4.427,2.573 2.75,0.198 10 false Generator Assembly 4.885,1.708 5.344,1.906 0.458,0.198 10 false LIN 3.083,1.531 3.24,1.729 0.156,0.198 10 false 2 4.552,1.531 4.865,1.729 0.313,0.198 10 false 135 2.792,1.698 3.25,1.896 0.458,0.198 10 false LIN 5.104,2.688 6.333,2.885 1.229,0.198 10 false ECM

PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
a.

Disconnect the C96 ECM connector.


b.

Disconnect the C60 generator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C96-135 (LIN) - C60-2 (LIN) Always Below 1 Ω
C96-135 (LIN) or C60-2 (LIN) - body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR