This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit | ·
Harness or connector ·
Speaker ·
Radio and display receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Disconnect the K4 radio and display receiver assembly connector.
Disconnect the K7 and K8 front No. 2 speaker assembly connectors.
Disconnect the Q1 and P1 rear speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K4-1 (FR+) or K7-4 (TWR+) - Body ground | Always | 10 kΩ or higher |
| K4-6 (FR-) or K7-2 (TWR-) - Body ground | Always | 10 kΩ or higher |
| K4-2 (FL+) or K8-4 (TWL+) - Body ground | Always | 10 kΩ or higher |
| K4-7 (FL-) or K8-2 (TWL-) - Body ground | Always | 10 kΩ or higher |
| K4-4 (RR+) or P1-1 - Body ground | Always | 10 kΩ or higher |
| K4-9 (RR-) or P1-2 - Body ground | Always | 10 kΩ or higher |
| K4-3 (RL+) or Q1-1 - Body ground | Always | 10 kΩ or higher |
| K4-8 (RL-) or Q1-2 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N1 and O1 front No. 1 speaker assembly connectors.
Disconnect the K7 and K8 front No. 2 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N1-2 or K7-3 (+) - Body ground | Always | 10 kΩ or higher |
| N1-1 or K7-1 (-) - Body ground | Always | 10 kΩ or higher |
| O1-2 or K8-3 (+) - Body ground | Always | 10 kΩ or higher |
| O1-1 or K8-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG