Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2017.09–2017.12
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Speaker Circuit  


DESCRIPTION

If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.

Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

E374888E01
0.188,1.104 1.458,1.625 1.271,0.521 10 false Front No. 1 Speaker Assembly RH 0.188,0.927 0.896,1.396 0.708,0.469 10 false N1 1.854,2.198 4.281,2.688 2.427,0.49 10 false Front No. 2 Speaker Assembly RH 0.208,3.708 1.479,4.229 1.271,0.521 10 false Front No. 1 Speaker Assembly LH 1.854,4.74 4.052,5.063 2.198,0.323 10 false Front No. 2 Speaker Assembly LH 0.219,3.49 0.927,3.958 0.708,0.469 10 false O1 0.5,5.375 1.396,5.938 0.896,0.563 10 false Rear Speaker Assembly RH 0.542,6.875 1.438,7.438 0.896,0.563 10 false Rear Speaker Assembly LH 5.875,7.938 7.063,8.552 1.188,0.615 10 false Radio and Display Receiver Assembly 5.833,7.75 6.531,8.229 0.698,0.479 10 false K4 0.542,6.688 1.438,7.25 0.896,0.563 10 false Q1 0.51,5.188 1.406,5.75 0.896,0.563 10 false P1 1.833,4.563 2.542,4.844 0.708,0.281 10 false K8 1.844,2.021 2.552,2.302 0.708,0.281 10 false K7 1.563,0.958 2.271,1.427 0.708,0.469 10 false 2 1.573,4.073 2.281,4.542 0.708,0.469 10 false 1 1.583,3.583 2.292,4.052 0.708,0.469 10 false 2 1.583,1.438 2.292,1.906 0.708,0.469 10 false 1 1.594,5.156 2.302,5.625 0.708,0.469 10 false 1 1.573,6.708 2.281,7.177 0.708,0.469 10 false 1 1.573,5.667 2.281,6.135 0.708,0.469 10 false 2 1.573,7.229 2.281,7.698 0.708,0.469 10 false 2 1.958,0.667 2.333,0.958 0.375,0.292 10 false 3 1.979,1.479 2.354,1.771 0.375,0.292 10 false 1 3.25,0.698 3.625,0.99 0.375,0.292 10 false 4 3.24,1.49 3.615,1.781 0.375,0.292 10 false 2 2.771,0.688 3.292,0.958 0.521,0.271 10 false TWR+ 2.781,3.313 3.313,3.677 0.531,0.365 10 false TWL+ 2.125,0.698 2.5,0.99 0.375,0.292 10 false + 2.135,1.49 2.51,1.781 0.375,0.292 10 false - 5.896,0.708 6.271,1 0.375,0.292 10 false 1 5.896,1.479 6.271,1.771 0.375,0.292 10 false 6 6.052,1.604 6.427,1.896 0.375,0.292 10 false FR- 6.052,0.813 6.427,1.104 0.375,0.292 10 false FR+ 6.042,3.438 6.417,3.729 0.375,0.292 10 false FL+ 6.042,4.24 6.417,4.531 0.375,0.292 10 false FL- 5.865,3.313 6.24,3.604 0.375,0.292 10 false 2 5.885,4.094 6.26,4.385 0.375,0.292 10 false 7 5.875,4.885 6.25,5.177 0.375,0.292 10 false 4 5.896,5.656 6.271,5.948 0.375,0.292 10 false 9 5.875,6.469 6.25,6.76 0.375,0.292 10 false 3 5.885,7.26 6.26,7.552 0.375,0.292 10 false 8 6.063,5.802 6.438,6.094 0.375,0.292 10 false RR- 6.052,5.01 6.427,5.302 0.375,0.292 10 false RR+ 6.042,6.594 6.417,6.885 0.375,0.292 10 false RL+ 6.042,7.396 6.417,7.688 0.375,0.292 10 false RL- 1.969,3.313 2.344,3.604 0.375,0.292 10 false 3 2.135,3.313 2.51,3.604 0.375,0.292 10 false + 1.979,4.104 2.354,4.396 0.375,0.292 10 false 1 2.125,4.115 2.5,4.406 0.375,0.292 10 false - 2.813,4.094 3.188,4.385 0.375,0.292 10 false TWL- 2.792,1.5 3.313,1.771 0.521,0.271 10 false TWR- 3.24,3.313 3.615,3.604 0.375,0.292 10 false 4 3.24,4.094 3.615,4.385 0.375,0.292 10 false 2


CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION


PROCEDURE

1.CHECK SPEAKER (OPERATION CHECK)
a.
E268474

Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK


b.

Perform the operation check above and determine the speaker that is not operating.

Result:
Not Operating Speaker Proceed to
Front No. 1 speaker assembly or front No. 2 speaker assembly A
Rear speaker assembly B


HINT:

If sound cannot be heard from any speaker, inspect all of them.




A

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - FRONT NO. 1 SPEAKER ASSEMBLY - FRONT NO. 2 SPEAKER ASSEMBLY)

B

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR SPEAKER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - FRONT NO. 1 SPEAKER ASSEMBLY - FRONT NO. 2 SPEAKER ASSEMBLY)
a.

Disconnect the K4 radio and display receiver assembly connector.


b.

Disconnect the N1 and O1 front No. 1 speaker assembly connectors.


c.

Disconnect the K7 and K8 front No. 2 speaker assembly connectors.


d.

Measure the resistance according to the value (s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K4-1 (FR+) - K7-4 (TWR+) Always Below 1 Ω
K4-6 (FR-) - K7-2 (TWR-) Always Below 1 Ω
K4-2 (FL+) - K8-4 (TWL+) Always Below 1 Ω
K4-7 (FL-) - K8-2 (TWL-) Always Below 1 Ω
N1-2 - K7-3 (+) Always Below 1 Ω
N1-1 - K7-1 (-) Always Below 1 Ω
O1-2 - K8-3 (+) Always Below 1 Ω
O1-1 - K8-1 (-) Always Below 1 Ω
K4-1 (FR+) or K7-4 (TWR+) - Body ground Always 10 kΩ or higher
K4-6 (FR-) or K7-2 (TWR-) - Body ground Always 10 kΩ or higher
K4-2 (FL+) or K8-4 (TWL+) - Body ground Always 10 kΩ or higher
K4-7 (FL-) or K8-2 (TWL-) - Body ground Always 10 kΩ or higher
N1-2 or K7-3 (+) - Body ground Always 10 kΩ or higher
N1-1 or K7-1 (-) - Body ground Always 10 kΩ or higher
O1-2 or K8-3 (+) - Body ground Always 10 kΩ or higher
O1-1 or K8-1 (-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT FRONT NO. 1 SPEAKER ASSEMBLY
a.

Remove the front No. 1 speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL


b.

Inspect the front No. 1 speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION


Result:
Proceed to
OK
NG



OK

4.REPLACE FRONT NO. 2 SPEAKER ASSEMBLY

NG

REPLACE FRONT NO. 1 SPEAKER ASSEMBLY

4.REPLACE FRONT NO. 2 SPEAKER ASSEMBLY
a.

Remove the front No. 2 speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL


b.

Inspect the front No. 2 speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR SPEAKER ASSEMBLY)
a.

Disconnect the K4 radio and display receiver assembly connector.


b.

Disconnect the Q1 and P1 rear speaker assembly connectors.


c.

Measure the resistance according to the value (s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K4-4 (RR+) - P1-1 Always Below 1 Ω
K4-9 (RR-) - P1-2 Always Below 1 Ω
K4-3 (RL+) - Q1-1 Always Below 1 Ω
K4-8 (RL-) - Q1-2 Always Below 1 Ω
K4-4 (RR+) or P1-1 - Body ground Always 10 kΩ or higher
K4-9 (RR-) or P1-2 - Body ground Always 10 kΩ or higher
K4-3 (RL+) or Q1-1 - Body ground Always 10 kΩ or higher
K4-8 (RL-) or Q1-2 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

6.INSPECT REAR SPEAKER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.INSPECT REAR SPEAKER ASSEMBLY
a.

Remove the rear speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL


b.

Inspect the rear speaker assembly.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION


Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG