The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during occupant detection sensor (separate type front seat cushion pad) removal/installation are shown below.
Wear protective gloves. Sharp areas on the parts may injure your hands.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for the RHD side and LHD side.
The following procedure is for the LHD side.
1.REMOVE FRONT SEAT ASSEMBLY
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL
73240
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY
71074S
3.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
71868N
4.REMOVE FRONT SEAT FRONT CUSHION SHIELD
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
71812D
5.REMOVE FRONT SEAT CUSHION SHIELD
71862
6.REMOVE FRONT SEAT INNER CUSHION SHIELD
7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>DISASSEMBLY
71512S
9.REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)
Using a screwdriver, disengage the 14 claws and remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.
| *a | Screwdriver | - | - |
87510L
10.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY (w/ Seat Heater System)
Use the same procedure as for the driver seat.
Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL