The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure regulator assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
| *a | Tube |
Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly of the fuel suction tube with pump and gauge assembly to be impossible as the tube is pressed into the fuel suction plate sub-assembly.
When replacing the fuel filter, replace it together with the fuel suction plate sub-assembly.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
3.REMOVE FUEL PUMP
23280J
4.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel filter.
Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.
Do not damage the fuel filter.
| *1 | O-ring |
Remove the 2 O-rings from the fuel pressure regulator assembly.